IL PORTALE per la RICERCA dei DIPARTIMENTI

FICHERA A, PAGANO A (2013) "A DYNAMICS-BASED TOOL FOR THE ANALYSIS OF EXPERIMENTAL TWO-PHASE FLOWS"

COSTA A, FICHERA S (2013) "A Genetic Algorithm for Scheduling both Jobs Families and Skilled Workforce"

I. BLANCO, F.A. Bottino, G. Cicala, A. Latteri, A. Recca (2013) "A Kinetic Study of the Thermal and Thermal Oxidative Degradations of New Bridged POSS/PS Nanocomposites"

CAMMARATA A, SINATRA R (2013) "A Novel Formulation for the Elastostatics of Spatial Mechanical Systems with Flexures"

CAMMARATA G, CAMMARATA L, PETRONE G (2013) "A Numerical procedure for PCM thermal storage design in solar plants"

BLANCO I, Cicala G, Mamo A, Recca A (2013) "A Thermal and Thermo-oxidative Degradations of Poly(2,6-dimethyl-1,4-phenylene oxide) (PPO)/Copoly(aryl ether sulfone) P(ESES-co-EES) Block Copolymers: a Kinetic Study"

Trapani N (2013) "A Weibull-based compositional approach for hierarchical dynamic fault trees"

Gagliano A, Nocera F, Patania F (2013) "A case study of Energy Efficiency Retrofit in social housing units"

Costa A, Fichera S (2013) "A dual encoding based meta heuristic algorithm for solving a constrained hybrid flow shop scheduling problem"

EVOLA G, MARLETTA L (2013) "A dynamic parameter to describe the thermal response of buildings to radiant heat gains"

Costa A, Fichera S (2013) "A hybrid genetic algorithm for job sequencing and worker allocation in parallel unrelated machines with sequence-dependent setup times"

EVOLA G, MARLETTA L (2013) "A methodology for investigating the effectiveness of PCM wallboards for summer thermal comfort in buildings"

Lanzafame R, Messina M (2013) "Advanced Brake State Model And Aerodynamic Post-Stall Model For Horizontal Axis Wind Turbines"

Pollicino A. (2013) "Advantages of Surface-Initiated ATRP (SI-ATRP) for the Functionalization of Electrospun Materials"

Cammarata A, Sinatra R (2013) "An Algorithm to Study the Elastodynamics of Parallel Kinematic Machines with Lower Kinematic Pairs"

Gagliano A, Nocera F, Patania F (2013) "Analysis of Constructive Technologies for improving Energy Performance of Buildings"

Pagano A, Fichera A (2013) "Analysis of the bifurcating orbits on the route to chaos in confined thermal convection"

Gagliano A, Nocera F, Patania (2013) "Assessment of micro-wind turbines performance in the urban environments: An aided methodology through geographical information systems"

Celano G, Fichera S (2013) "Comparison of the Xbar chart and the t chart when the parameters are estimated"

Compagno L., D'URSO D (2013) "Conception of Repairable Dynamic Fault Trees and Resolution by the use of RAATSS, a Matlab® Toolbox Based on the ATS Formalism"

Failla S (2013) "Controlling the Molecular Self-Assembly into Nanofibers of Amphiphilic Zinc(II) Salophen Complexes"

Evola G, Marletta L (2013) "Cool roofs for passive cooling: performance in different climates and for different insulation levels in Italy"

Evola G, Marletta L (2013) "Cost-effective design solutions for low-rise residential Net ZEBs in Mediterranean climate"

RISITANO A (2013) "Determining of fatigue limits with termal anlalysis of static traction test"

Mirone G (2013) "Development of a Shape Memory Alloy: Activated Clamping Device for Split Hopkinson Tension Bars"

MIRONE G (2013) "Ductile failure of X100 pipeline steel- Experiments and fractography."

MANCINI G (2013) "Effect of powdered activated carbon to reduce fouling in membrane bioreactors: A sustainable solution. Case study"

Gagliano A (2013) "Energetic sustainability of the building substitution: the rewards and the facilitations of the Italian Piano Casa"

La Rosa A, Alberta Latteri (2013) "Environmental benefits of using ground tire rubber in new pneumatic formulations: a life cycle assessment approach"

SEQUENZIA G, OLIVERI S, CALI' M (2013) "Experimental methodology for the tappet characterization of timing system in I.C.E."

Fichera A, Pagano A (2013) "Extraction of the dominant features of complex dynamics in experimental air-water two-phase flows"

Fargione G (2013) "Fatigue characterization of mechanical components in service"

Siracusa V (2013) "Fully aliphatic copolyesters based on poly(butylene 1,4- cyclohexanedicarboxylate) with promising mechanical and barrier properties for food packaging applications"

Di Pasquale G (2013) "IP2C sensor modeling"

G.Cicala, I. BLANCO, A.Recca (2013) "Influence of 1,5-naphthalenediamine on thermomechanical properties of epoxy/coPES blends"

Gagliano A (2013) "Intelligent sun-tracking system based on multiple photodiode sensors for maximisation of photovoltaic energy production"

Di Pasquale G, Pollicino A (2013) "Ionic electroactive polymer metal composites: Fabricating, modeling, and applications of postsilicon smart devices"

I. BLANCO, V. Siracusa (2013) "Kinetic study of the thermal and thermo-oxidative degradations 4 of polylactide-modified films for food packaging"

Recca A (2013) "LCA of a novel hybrid glass-hemp/thermoset composite. JOURNAL OF CLEANER PRODUCTION, vol. 44, p. 69-76, ISSN: 0959-6526, doi: 10.1016/j.jclepro.2012.11.038"

La Rosa A (2013) "Life cycle assessment of a novel hybrid glass-hemp/thermoset composite"

Latteri A, Recca A, Cicala G (2013) "Life cycle assessment of a novel hybrid glass-hemp/thermoset composite"

Consiglio Giuseppe (2013) "Modeling, design and synthesis of new heteroaryl ethylenes active against the MCF-7 breast cancer cell-line"

Celano G (2013) "Monitoring the coefficient of variation using a variable sampling interval control chart"

Celano G (2013) "Monitoring the coefficient of variation using control charts with run rules"

CAMMARATA G, PETRONE G (2013) "NUMERICAL SIMULATION OF PHASE CHANGE MATERIALS MELTING PROCESS"

PAGANO A (2013) "Nonlinear dynamics of a confined buoyant flow"

Mancini G (2013) "Numerical approach to modelling pulse-mode soil flushing on a Pb-contaminated soil"

CAMMARATA G (2013) "Numerical multi-physical approach for the assessment of coupled heat and moisture transfer combined with people movements in historical buildings"

Gagliano A, Nocera F (2013) "Performance assessment of a solar assisted desiccant cooling system"

Celano G, Fichera S (2013) "Performance of t control charts in short runs with unknown shift sizes"

Gagliano A, Nocera F, Patania F (2013) "Photovoltaic glazing: analysis of thermal behavior and indoor comfort"

Evola G (2013) "Progettare un net ZEB in clima mediterraneo"

EVOLA G (2013) "Proposal and validation of a model for the dynamic simulation of a solar-assisted single-stage LiBr/water absorption chiller"

Evola G, Marletta L (2013) "Rafraichissement par machine à absorption: opportunité d'une climatisation solaire"

MIRONE G (2013) "Sensitivity Analysis on triaxiality factor and Lode angle in ductile fracture"

MARLETTA L (2013) "Simulation of a ventilated cavity to enhance the effectiveness of PVC wallboards for summer thermal comfort in buildings"

Mirone G, Corallo D (2013) "Stress–strain and ductile fracture characterization of an X100 anisotropic steel: Experiments and modelling"

Evola G, Gagliano A, Nocera F (2013) "Study on the application of cool paintings for the passive cooling of existing buildings in mediterranean climates"

Fichera S (2013) "The Variable Parameters T2 control chart with run rules."

Mirone G (2013) "The dynamic effect of necking in Hopkinson bar tension tests"

I. BLANCO, F.A. Bottino (2013) "The regression of isothermal thermogravimetric data to evaluate degradation Ea values of polymers: a comparison with literature methods and an evaluation of lifetime predictions reliability. Part II"

Celano G, Fichera S (2013) "The variable sample size t control chart for monitoring short production runs"

Evola G, Marletta L (2013) "Thermal Analysis of a Hybrid-Photovoltaic/thermal Solar Collector"

I. BLANCO, F. A. Bottino (2013) "Thermal Study on Phenyl, Hepta Isobutyl-Polyhedral Oligomeric Silsesquioxane/Polystyrene Nanocomposites"

Cammarata G, Cammarata L (2013) "Thermodynamic analysis of ORC for energy production from geothermal resources"

Fichera A. (2013) "Two-dimensional numerical analysis of a rectangular closed-loop thermosiphon"

Famoso F (2013) "Urban mobility management: new challenges for a sustainable future "

I. BLANCO, F.A. Bottino (2013) "Variously substituted Phenyl hepta Cyclopentyl - Polyhedral Oligomeric Silsesquioxane (ph,hcp-POSS)/Polystyrene (PS) nanocomposites. The influence of substituents on the thermal stability"

Pollicino A (2013) "Water resistance improvement of filter paper by a UV-grafting modification with a fluoromonomer"

Lanzafame R., Messina M (2013) "Wind turbine CFD Modeling using a correlation based transitional model"