IL PORTALE per la RICERCA dei DIPARTIMENTI

Forte Paola (2013) "A Computational Investigation of the Steady State Vibrations of Unbalanced Flexibly Supported Rigid Rotors Damped by Short Magnetorheological Squeeze Film Dampers"

Gualtiero Fantoni, Marco Santochi (2013) "A new capillary gripper for mini and micro parts"

Guido Buresti (2013) "A note on the effect of the separation wall in the initial mixing of coaxial jets"

GALLETTI C., Tognotti L. (2013) "A novel methodology for chemical time scale evaluation with detailed chemical reaction kinetics"

Ambrosini W. (2013) "Analysis of flow stability in nuclear reactor subchannels with water at supercritical pressures"

Ambrosini W. (2013) "Assessment of a new model for the linear and nonlinear stability analysis of natural circulation loops with supercritical fluids"

G. Fantoni (2013) "Automatic extraction of function-behaviour-state information from patents"

Elisabetta Rosellini (2013) "Biomimetic poly(glycerol sebacate) (PGS) membranes for cardiac patch application"

Michele Lanzetta (2013) "CAD model based virtual assembly simulation, planning and training"

Ambrosini W. (2013) "CFD analysis of the dynamic behaviour of a fuel rod subchannel in a supercritical water reactor with point kinetics"

F. d’Errico, R. Ciolini (2013) "Calibration of PADC-based neutron area dosemeters in the neutron field produced in the treatment room of a medical LINAC"

d'Errico F. (2013) "Clinical simulations of prostate radiotherapy using BOMAB-like phantoms: Results for neutrons"

d'Errico F. (2013) "Clinical simulations of prostate radiotherapy using BOMAB-like phantoms: Results for photons"

VALVO P.S. (2013) "Cohesive failure analysis of an array of IC chips bonded to a stretched substrate"

TOGNOTTI L (2013) "Comparing reaction orders of anthracite chars with bituminous coal chars at high temperature oxidation conditions"

Ambrosini W. (2013) "Developing a CFD methodology for the analysis of flow stability in heated channels with fluids at supercritical pressures "

Ambrosini W. (2013) "Discussion on the stability of natural circulation loops with supercritical pressure fluids"

Giusti V (2013) "Dosimetry for gadolinium neutron capture therapy (GdNCT)"

Artoni A., Gabiccini M. (2013) "Ease-off based compensation of tooth surface deviations for spiral bevel and hypoid gears: only the pinion needs corrections"

Giuseppe Gallone (2013) "Effects of plasticization of a soft silicone for dielectric elastomer actuation"

Quarta A, Mengali G. (2013) "Electric solar wind sail mass budget model"

Marradi A. (2013) "Evaluation of cement treated mixtures with high percentage of reclaimed asphalt pavement"

D. Fanteria, A. Lanciotti (2013) "Experimental and analytical assessment of fatigue and crack propagation in cold worked open hole specimens"

Ambrosini W., Forgione N. (2013) "Experimental and computational analysis of steam condensation in the presence of air and helium"

Lorenza Mattei (2013) "Finite element analysis of the meniscectomised tibio-femoral joint: implementation of advanced articular cartilage models"

Leonardo Tognotti (2013) "Flame characteristics of pulverized torrefied-biomass combusted with high-temperature air"

R. Ciolini, F. D'Errico (2013) "Functional test of a Radon sensor based on a high-resistivity-silicon BJT detector"

Michele Lanzetta (2013) "Gripping by controllable wet adhesion using a magnetorheological fluid"

G. Fantoni (2013) "How microtool dimension influences electrochemical micromachining"

Camarri S. (2013) "Linear stability analysis of wind turbine wakes performed on wind tunnel measurements"

Orsi G (2013) "Mapping the pharyngeal and intestinal pH of Caenorhabditis elegans and real-time luminal pH oscillations using extended dynamic range pH-sensitive nanosensors"

A. Bertei, C. Nicolella (2013) "Microstructural Modeling and Effective Properties of Infiltrated SOFC Electrodes"

Nicolella C (2013) "Proof of concept for the Dual Membrane Cell. Part II: Mathematical modeling of charge transport and reaction in the dual membrane."

d'Errico F. (2013) "Radiotherapy out-of-field dosimetry: Experimental and computational results for photons in a water tank"

G Gallone (2013) "Reinforced poly(propylene oxide): a very soft and extensible dielectric electroactive polymer"

Artoni A., Guiggiani M. (2013) "Robust optimization of cylindrical gear tooth surface modifications within ranges of torque and misalignments"

Camarri S (2013) "Stability analysis of experimental flow fields behind a porous cylinder for the investigation of the large-scale wake vortices"

Elisabetta Rosellini (2013) "Sterilization effects on the physical properties and cytotoxicity of poly(glycerol sebacate)"

G. Lombardi (2013) "Study of Rigid Sail Aerodynamics"

Carloni D., Paci S. (2013) "Thermal hydraulic feasibility analysis of the IBED PHTS for ITER"

Gonfiotti B, Paci S (2013) "Thermal-hydraulic-iodine chemistry coupling: Insights gained from the SARNET benchmark on the THAI experiments Iod-11 and Iod-12"

Quarta A (2013) "Time-Optimal Trajectories to Circumsolar Space Using Solar Electric Propulsion"

Hamal Marino (2013) "Transitions between discrete and rhythmic primitives in a unimanual task"

Barsotti R (2013) "Wrinkling of orthotropic membranes: an analysis by the polar method"

d'Errico F. (2013) "Superheated emulsions and track etch detectors for photoneutron measurements"

Giusti V. (2013) "High Precision Cross Sections and Physics Models for Proton Interactions Below 20 MeV in Geant4 "